esp-s

ESP-S is the plastic protector strengthened by steel coat. This type is made from injection moulded blank which is pressed into steel housing. Size from 6 5/8" up to 24". Final operation is threading on CNC machine. Most of them would be produced in CEL, CENL and OED configuration.

CENL BOX configuration can not be produced due to technical reasons. If necessary to use this configuration, the hole in the protector is closed by special end cap.

esp-s cel box

esp-s cel box CEL BOX /closed end liftable/ means closed protector which covers inner thread and allows for lifting the pipe at the end with attached protector.

Interactive 3D PDF files look exactly like the original 3D design

esp-s cel pin

esp-s cel pin CEL PIN /closed end liftable/ means closed protector which covers outer thread andallows for lifting the pipe at the end with attached protector.

Interactive 3D PDF files look exactly like the original 3D design

esp-s cenl pin

esp-s cenl pin CENL PIN /closed end non liftable/ means closed protector which covers outer thread anddoes not allow for lifting the pipe at the end with attached protector.

Interactive 3D PDF files look exactly like the original 3D design

 

spacer rings

spacer rings Spacer rings/pipe protection rings/bumper rings provides improved protection during handling to avoid contact between pipes especially for high alloy tubulars. Spacer rings are produced from impact resistant PE in a wide temperature range. We can produce any custom diameter from 2" up to 16".